1. Operation Procedures of the spray booth：

Clean the inner parts of the spray booth (including wall panel, ceiling filter and floor) and the automobiles ready to be sprayed ；

Close tightly the doors of the spray booth, turn on fan and the air compressor, turn on the lighting, and blow the booth inside from the top and down with compressed air and the automobile is ready to be sprayed.

After finishing the above cleaning work, the paint spray is ready to start. If the ambient temperature is below 20℃, turn the ignition switch to the heating spraying position to ensure the temperature in the booth is 20℃ in order to ensure the paint has good fluidity.

2. Operation Procedures of baking lights：

Connect input power with 20A or above power electrical plug, socket and switch. If cable need to be lengthened, should use 4mm2  or above rubber cover.

Adjust needed pre-baking and drying time. Space between lights and products is 0.5M。

Turn on operation switch, heater works.

light tray angle adjust，if light tray needs to be up and down，release angle lock knob, and lock tightly after adjusting.

Cautions on Using spray booth

1.Keep floor clean. Before spraying, clean the floor with water every time.

2.Before spraying, automobiles should be cleaned out. And remove the dangerous goods, which are inflammable and exposable (expect the gasoline in the gasoline tank) from the automobiles.

3.During spraying, reduce pass in and out of the booth to keep out of the dust.

4.Workers should wear work clothes and change shoes before entering the booth. Smoking is strictly prohibited inside the booth.

5. Expect spray gun and oil carrier, no more paint materials put in the booth.

6.Any mosquitoes in the booth, use mosquito pesticide before spraying